Nuvo NV-D2120 Installation Manual

Also see for NV-D2120: Installation guide Installation guide

Contents

Nuvo NV-D2120 Installation Manual Manual pdf 13 page image

IV. Trigger InThis input (Fig. 8) is designed for a mono 1/8” plug to accept a trigger voltage coming in from an external source.Any voltage ranging from 3 to 30 volts, AC or DC, will cause the amplifier to turn on when the Power switch is in the Trigger mode.Fig. 8V. Unit OnThis output (Fig. 9) provides a constant 12 volts DC when the amplifier is powered on. This is useful for powering on external equipment with theD2120.Fig. 9VI. Speaker ImpedanceThis switch (Fig. 10) allows for the adjusting of the impedance of the amplifier. By default the amplifier will be set at 8 ohms. This is fine is you arepowering a pair of 8 ohm speakers, or a single stereo speaker rated at 8 ohms. In installations where three or more 8 ohm speakers will be used, ora pair of 4 ohm speakers are being utilized, the impedance of the amplifier should be set to 4 ohms. The power of the output will remain at 120watts per channel.Fig. 1013

/ 16

Related manuals for Nuvo NV-D2120