16IV. Using the Coordinator/Repeater as a Repeater (Fig. 10)In some cases, good communication between the Wireless Control Pads and theSystem's Coordinator may be challenged. Installing an additionalCoordinator/Repeater NV-WCPR component as an intermediate signal repeater oftencan extend communication distance. This is easily done by setting the rotary switch onthe bottom of the additional Coordinator/Repeater to the “R” position. Then plug theincluded USB power supply into the Coordinator and into an AC outlet. If desired, theRepeater can be powered by NuVoNet.To initially establish a connection to the coordinator, plug in the NV-WCPR in closeproximity to the System’s Coordinator. Look for the SETUP LED to flash slowly andsteadily. It will flash while it is establishing communication with the Coordinator.When it remains lit, press the SETUP button on the Coordinator and then on theRepeater. The LED will turn off, indicating that Coordinator and Repeater arecommunicating.Figure 10 – Using the Coordinator/Repeater as a RepeaterPOWER SETUP The SETUP LEDflashes slowly whileit searches for theCoordinator.Set the Peripheral Deviceaddress to “R”.