Installing the CPU FanThere are many different fan types that can be used with this motherboard. Follow theinstructions that came with your fan assembly. Be sure that the fan orientation is correctfor your chassis type and your fan assembly.Installing Memory DIMMsYour new motherboard has four 1.8V 240-pin slots for DDR2 memory. These slotssupport 256 MB, 512 MB and 1 GB DDR2 technologies for x8 and x16 devices. Theyalso support dual channel DDR2 memory technology up to 10.7GB/s. There must be atleast one memory bank populated to ensure normal operation. Use the following therecommendations for installing memory.• One DIMM: Install into slot 0. You can install the DIMM into any slot; however, slot 0is preferred.• Two DIMMs: Install into either slots 0 and 1 or 2 and 3. To take full advantage of dual-channel memory, alternating slots should be populated. For example with two DIMMs,slots 0 and 1 should be used.• Four DIMMS: Install into slots 0, 1, 2, and 3.Use the following procedure to install memory DIMMs into the slots on the motherboard.Note that there is only one gap near the center of the DIMM slot. This slot matches theslot on the memory DIMM to ensure the component is installed properly.1. Unlock a DIMM slot by pressing the module clips outward.2. Align the memory module to the DIMM slot, and insert the module vertically into theDIMM slot. The plastic clips at both sides of the DIMM slot automatically lock theDIMM into the connector.13Hardware InstallationCPU sideCard-edge sideDIMM Slot 0DIMM Slot 2DIMM Slot 1DIMM Slot 3