Nyos QUANTUM 120 Instructions Manual
Also see for Quantum 120: InstructionsInstructions
                    | |
INSTALLATION AND COMMISSIONINGYou receive your NYOS® Quantum® skimmer as plug-and-play model.The only thing you have to install is the pump. To do so, open the four ti-tanium screws (part no. 22, see p.20) on the body as well as two screwsof one pump holding (part no. 22, p.20). Put the pump in place and ins-tall the pump holding again. Mount the bubble plate on the pump outlet,reinstall the body and put the venturi (part no. 16, p. 20) on pump inlet.Inspect your skimmer immediately upon receipt for completeness andany transport damages. You must notify the dealer within 48 hours of anydefects.Step 1: Positioning in the filter tank• Remove the skimmer from the box. Remove the protective film fromthe cover of the skimmer cup. Install the skimmer cup.• Position the skimmer in the sump. For the skimmer to work perfectly, thewater level in the sump should be approx. 21 cm (8 in). The device maynot be in contact with the side glass panes of the sump. The suction sideof the pump requires at least 5 cm (2 in) of space.• To keep the water at a consistent level, an automatic level regulatorfor water lost through evaporation or a filter chamber with a consis-tent water level is recommended. Fluctuations in water level affectthe skimming performance.Step 2: Setting devices• Before using your skimmer, learn about the setting devices. Knowinghow these are interconnected is required to adjust your device per-fectly.• You can set the air and water volume respectively water level separa-tely on your skimmer.• You can regulate the water level through the water level control tube(rough adjustment) and the micro-adjustment screw (more preciseadjustment „OPEN-CLOSE“)• You adjust the water level roughly by turning the control tube.14 |
Related manuals for Nyos Quantum 120
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine