OHAUS Adventurer AX124/E User Manual

Also see for Adventurer AX124: Instruction manual Instruction manual User guide Instruction manual Service manual

Contents

OHAUS Adventurer AX124/E User Manual Manual pdf 6 page image

EN-4MENU & SCREEN NAVIGATIONTouch Menu to open the menu list.Calibration:Touch to view calibration options.Balance Setup:Touch to view and change balance settings.Weighing Units:Touch to view and change weighing units.Data Maintenance:Touch to view data maintenance settings.Communication:Touch to view COM Device Settings and PrintSettings.Factory Reset:Touch to do a Factory reset of menu settings.GLP and GMP Data:Insert user data for traceability.Lockout:Touch to view lockout options.3.2 Using the BalanceNote: Before using any application, be sure the balance has been leveled and calibrated.Weighing Application1. If required, place an empty container on the pan and press Tare.2. Add sample to the pan or container. The display shows the weight of the sample.4. MAINTENANCE4.1 CleaningWARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.Make sure that no liquid enters the interior of the instrument.Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.4.2 TroubleshootingFor technical issues contact an Authorized Ohaus Service Agent. Please visit our website www.ohaus.com to locate theOhaus office nearest you.5. TECHNICAL DATAThe technical data is valid under the following conditions: Indoor use only Altitude: Up to 2000 m Specified Temperature range: 10°C to 30°C Humidity: maximum relative humidity 80 % for temperatures up to 30°C decreasing linearly to 50% relative humidity at 40°C Mains supply voltage fluctuations: up to ±10% of the nominal voltage Installation category II Pollution degree: 2