OHAUS Adventurer AX124 Instruction Manual

Also see for Adventurer AX124: Instruction manual Instruction manual User guide Service manual User guide

Contents

OHAUS Adventurer AX124 Instruction Manual Manual pdf 58 page image

EN-56 ADVENTURER BALANCES9.4 Communication9.4.1 Interface CommandsCommands listed in the following table will be acknowledged by the balance.The balance will return “ES” for invalid commands.TABLE 9-6. ADVENTURER INTERFACE COMMAND LISTCommandCharacters FunctionIP Immediate Print of displayed weight (stable or unstable).P Print displayed weight (stable or unstable).CP Continuous Print.SP Print on Stability.SLP Auto Print stable non-zero displayed weight.SLZP Auto Print stable non-zero weight and stable zero reading.xP Interval Print x = Print Interval (1-3600 sec) 0P ends interval Print0P See aboveH Enter Print Header LinesZ Same as pressing Zero KeyT Same as pressing Tare Key.xT Establish a preset Tare value in displayed unit. X = preset tare value. Sending 0T clears tare (ifallowed).PT Prints Tare weight stored in memory.ON Brings out of StandbyOFF Goes to Standby.C Begin Span CalibrationIC Begin internal Calibration, same as trigger from calibration menu.AC Abort Calibration. Attention: when LFT ON, the operation is not allowed.PSN Print Serial Number.PV Print terminal software version, base software version and LFT ON (if LFT is set ON).x# Set Counting APW (x) in grams. (must have APW stored)P# Print Counting application APW.x% Set Percent application reference weight (x) in grams. (must have reference weight stored)P% Print Percent application reference weight.xS 0 = print unstable data, same as IP; 1 = print stable only1), same as SP.xRL 0 = disable response; 1 = enable response. This command only controls the “OK!” response.