OHAUS CD-31 Instruction Manual

OHAUS CD-31 Instruction Manual Manual pdf 20 page image

20CD Indicators3.5 PrintThe Print menu provides a number of options which can be turned ON or OFF. It contains 8 submenus: Auto Print,Inter, Stable, Numeric, GMPCont, GMP Tare, Reference and Lock. See descriptions below.Procedure• Press the Setup button, SCALE is displayed.• Press or button until PRINT is displayed.• Press Enter button to continue.• Press or button until either AUTOPRT,INTER, STABLE, NUMERIC, GMPCONT, GMPTARE,REFEREN, LOCK or EXIT is displayed.• Press Enter button to continue.• Press or button and select either menusetting or ON or OFF.• Press Enter button to save setting.• Press or button to select next item or EXIT.• Press Enter button to continue.Auto Print FeatureWhen enabled, the Auto Print feature causes the Indicator to automatically output display data in one of three ways:continuously, at user specified time intervals, or upon stability. Default settings are shown bold.OFF when set on turns off the auto print featureCont when set on, outputs printed data continuouslyInter provides a user specified printing intervalOn Stb provides printed data only when a stable reading is achievedIntervalCan be set to provide a specified printing interval between 1 and 3600 seconds.Print Stable Data OnlyWhen set On, permits only stable display data to be output. OFF is the default setting.Print Numeric Data OnlyWhen Numeric Data Only function is turned ON, this allows the indicator to output numeric data only for RS232 output.OFF is the default setting.GMP ContinuouslyWhen the GMP Continuously function is set ON, it allows the Indicator to output the GMP selections each time aweight value is printed to the printer. OFF is the default setting.GMP Once After TareWhen the GMP Tare function is set ON, it allows the Indicator to output the GMP selections once after tare when theweight value is printed to the printer. OFF is the default setting.ReferenceWhen the Reference function is set ON, it prints the value of weight used as a reference in either Percent and PartsCounting modes. OFF is the default setting.LockLock ON/OFF can only be changed when the hardware Lock Switch is disabled (jumper on). A menu is locked whenthe menu lock is set ON and the Lock Switch is enabled (jumper off). Lock when selected and turned on, locks all ofthe entries made under the Print menu. In the locked condition, items may be looked at but not changed in the menu.When set off, entries may be changed. OFF is the default setting.