OHAUS Defender 2000 Series Instruction Manual

Also see for Defender 2000 Series: Instruction manual Instruction manual

Contents

Defender 2000 Series Base EN-1INTRODUCTIONThis manual covers installation, and maintenance instructions for the Ohaus Defender TM 2000 Series Base. Please read thismanual completely before installation and operation.SAFETY PRECAUTIONSFor safe and dependable operation of this product, please comply with the following precautions: Operate the base only under ambient conditions specified in these instructions Ensure that the load cell cable does not pose an obstruction or tripping hazard Do not operate the base in hazardous environments or unstable locations Do not drop loads on the base Do not lift the base by the top frame; always lift from the bottom frame when moving the base Service should only be performed by authorized personnel To avoid injury, use caution when lifting or moving the baseINSTALLATIONUnpackingUnpack and inspect the product to make sure that all components have been included. The package includes the following:• Defender TM 2000 Series Base • Weighing Pan • Warranty Card• Instruction Manual • Column Assembly • Quick Start GuideWARNING: Lifting Hazard. The bases weigh between 9.5 kg ( 20.9 lb) and 38.5 kg (84.9 lb). Single personlift could cause injury. Use assistance when lifting or moving the base.AssemblyWeighing PanPlace the weighing pan on the top frame of the base.Wiring ConnectionsThe load cell cable is soldered to the load cell connector as below:Note: To connect Defender 2000 base to another indicator besides T24PE, please cut the load cell connector and connectdirectly.Selecting the LocationTo ensure accuracy, proper performance and safety, locate and operate the base on a stable, level surface. Avoid locations withrapid temperature changes or excessive dust, air currents, vibrations, electromagnetic fields or heat.Level the base by adjusting the four leveling feet until the bubble in the level indicator (located at the rear of the base) is centered.A wrench may be needed to loosen the locking nut above each leveling foot. When the base is level, retighten the locking nutsup against the base to lock each foot into place.Note: Ensure that the base is level each time its location is changed.CORRECT INCORRECTPin Connection1 +EXE2 +SEN3 +SIG4 GND5 -SIG6 -SEN7 -EXE