OHAUS Defender Series Service Manual

Also see for DEFENDER SERIES: Assembly instructions Instruction manual Instruction manual Instruction manual User guide

Contents

OHAUS Defender Series Service Manual Manual pdf 21 page image

20 Defender™ Series Bases Service Manual4.5.2 Adjusting Off Center LoadIf the Off Center Load (Shift) is excessive, perform adjustment as follows:Figure 4-2. Off Center Load adjustment points.1. Place the test weight in the center of the Platform.2. Tare the indicator.3. Move the weight to point A and record the reading.4. Move the weight to point B and record the reading.5. Move the weight to point C and record the reading.6. Move the weight to point D and record the reading.7. If the reading at point A is negative, file at points 1 and 4 AT AN ANGLE.8. If the reading at point B is negative, file at points 1 and 2 STRAIGHT ACROSS.9. If the reading at point C is negative, file at points 2 and 3 AT AN ANGLE.10. If the reading at point D is negative, file at points 3 and 4 STRAIGHT ACROSS.Note: It is not recommended that you try to adjust more than –5 counts if the beam has been filedalready. If the beam has not been filed previously, you can adjust –10 counts. Remember, when filingyou are weakening the beam. File a little at a time.Top view of Load CellSide view of Load Cell12 34