OHAUS RA Series Installation Manual
Also see for RA Series: Operation manual
                    | |
EN-12 RA Series6.2 Type Approval SealingAfter the scale has been found to comply with local regulations by respectiveapproving authorities, the scale may be sealed in the following manner:6.2.1 Lead and Wire Seal(1) Install the 2 through-hole sealing screws securely as illustrated below.Run thw wire seal into the through-holes, then apply the lead seal in place.6.2.2. Sticker SealInstall 2 regular pan-head screws, then apply a sticker over one of the screwsor on one of the through-holes for the housing screw (2).7. MAINTENANCE7.1 CleaningComply with safety precautions when cleaning and maintaining the scale• Turn off and disconnect the scale from the power supply during cleaning.• Wipe the exterior components of the scale using a soft cloth dampenedwith water and a mild detergent (DO NOT use acids, alkalis, strongsolvents or abrasive cleaning agents).• Inspect the scale regularly. Ensure that the housing, pan and sub-platform are clean and free from foreign material.• DO NOT allow liquids to enter the scale.• DO NOT open the scale; no user repairable components inside. Serviceshould be performed by authorized personnel only.• DO NOT carry the scale by the pan or sub-platform. Use the handholdbehind the scale housing.• DO NOT place the scale upside down. If accessing the bottom, place thescale on its side.2 |
Related manuals for OHAUS RA Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine