OHAUS RC31P1502 Instruction Manual

Also see for RC31P15: Instruction manual Instruction manual Instruction manual User guide Instruction manual

Contents

Ranger™ Count 3000 Series EN-5TABLE 3-1. Cont.ButtonPrimaryFunction(Short Press)0-9Enter numericvalues on thedisplay.Enter decimalpoint (.) on thedisplay.CClear the lastcharacterfrom thedisplay.TarePerform atareoperation.SampleDisplay/Startnew APWSecondaryFunction(Long Press)Switch betweenscale 1 andscale 2(only availableif secondplatform isconnected)+/-Switchbetweenpositive andnegativevalueNotes: 1 Short Press: Press less than 1 seconds.2 Long Press: Press and hold for more than 2 seconds.TABLE 3-2. LCD SymbolsItem Description Item Description1 NET symbol 10 Low Sample Weight Symbol2 Center of Zero symbol 11 Auto Optimization Symbol3 Negative symbol 12 Dynamic symbol (not used)4 Stable weight symbol 13 Battery charge symbol5 Preset Tare, Tare symbols 14 Pound, Ounce, Pound:Ounce symbols6 Pointer symbols 15 Percent symbol (not used)7 Accumulation symbol 16 Kilogram, gram symbols8 Calibration / Menu Mode symbol 17 Pieces symbol, tonne symbol (not used)9 Low Average Piece Weight Symbol 18 Scale symbol (only shown when 2ndplatform is connected and turned on)Notes:The APW Lo symbol will be lit if the APW value is lower than minimum recommended APW (refer to table 7-1 forminimum APW).The Wt Lo symbol will be lit if the sample weight is lower than minimum recommended sample weight (refer toTable 7-1 for minimum sample weight).17 8 10 11 12 131415Figure 3-2. LCD Displays.234569161718Piece WeightWeight