USB Device Interface EN-1INTRODUCTIONThis Interface Kit is for use with OHAUS Scout STX, SPX, SKX and SJX seriesproducts.The OHAUS USB Interface Kit is a unique solution to the problem of connecting abalance to a computer using a Universal Serial Bus (USB). The USB Interface kitincludes a CD with the software drivers to create the required virtual port on thecomputer.SYSTEM REQUIREMENTS PC running Windows 98®, Windows 98SE®, Windows ME®, Windows2000®, Windows XP® or Windows 7® Be forward compatible with iMac 10.7 (contact with OHAUS) Available USB portINTERFACE INSTALLATIONInstall the Interface module on the mini DIN port (round connector) located at therear side of the balance as shown. During this process, please make sure thebalance is powered off.Notes: Please make sure the small triangle mark (▲) on the round connector isat the bottom and then plug in. The appearance of your model may be different.SETUPA) The OHAUS Interface is preset to communicate using the following settings:9600 baud, 8 bit, no parity, no handshake. Determine the USB Deviceparameters required for the computer that is to be connected. If theparameters do not match, it will be necessary to change either the balancesettings, or the computer settings.B) Upon installation of the interface, the balance will recognize the USB DeviceInterface and add relevant items to the menu. Configure the balance to thedesired USB and printing parameters; refer to the balance Instruction Manualfor assistance in using the menus.Mini DIN port(Round connector)