OHAUS skx series Instruction Manual

Also see for Scout Series: Instruction manual

Contents

OHAUS skx series Instruction Manual Manual pdf 5 page image

SCOUTTM SERIES BALANCES - SKX EN-32.4 Connecting PowerAC Adapter InstallationAC power is used to power the scale when battery power is not needed. First, connect the ACAdapter (supplied) to the AC Adapter Input receptacle at the rear of the balance then connectthe AC plug to an electrical outlet.Figure 2-3. Rear and bottom view of balanceBattery InstallationInstall the four “AA” batteries with polarity as shown in the battery compartment.Note:After power on, it is recommended to let the balance warm up for at least 5 minutes beforeusing it.2.5 Initial CalibrationWhen the Balance is first installed, and when it is moved to another location, it must becalibrated to ensure accurate weighing results. The balance can be manually calibrated withexternal masses. Have the appropriate calibration masses available before beginningcalibration. Refer to the Calibration Section for masses and calibration procedure.AC Adapter Input JackBattery Compartment CoverInterface ConnectionSecurity SwitchWeigh Below HoleSecurity slot (Anti-theft lock slot)