Oakton 35631-00 Operating Instructions Manual

Oakton 35631-00 Operating Instructions Manual Manual pdf 18 page image

3534P7.2 Selecting °C or °FThis meter lets you select between °C and °F units for temperature readings.From measurement mode1. Press the Mode key to selectconductivity or TDS measurement mode.2. Press Setup key to enter Set Up mode.3. Press the s and t keys to scroll throughsubgroups until you view parameter P7.0.See figure4. Press the ENTER key four times to selectparameter 7.2.See figure5. Press the s and t keys to toggle between°C and °F.6. Press the ENTER key to confirm selectionand to proceed to step 4 of P7.3. Press theCAL/MEAS key twice to return to meas-urement mode.mSSETUPμSpptppmCCDNotesYou can also switch between °C and °F in Program P3.3 (available from pH mode).If you switch between °C and °F in conductivity mode, the meter will also switch inpH mode.CSETUPFSETUPDFrom measurement mode1. Press the Mode key to selectconductivity or TDS measurement mode.2. Press Setup key to enter Set Up mode.3. Press the s and t keys to scrollthrough subgroups until you viewparameter P7.0.See figure4. Press the ENTER key to selectparameter 7.1.See figure5. Press the s and t keys to select theconfiguration you require.•ON switches the READY indicator on.•OFF switches the READY indicator off.•ON and HOLD together switches theauto endpoint feature on.6. Press the ENTER key to confirm selectionand to proceed to step 4 of P.7.2. Press theCAL/MEAS key twice to return to meas-urement mode.P7.0: Conductivity/TDS measurement configurationP7.1: READY indicator and auto endpoint functionThis program lets you select:• “READY indicator on” to indicate when the reading is stable.• “READY indicator off” for faster meter response.• Auto endpoint function on. Select auto endpoint on to “hold” the reading whenit is stable for more than 5 seconds. The display automatically freezes, and theHOLD indicator appears on the left side of the display. Press the HOLD key torelease the display and access other functions.mSSETUPμSpptppmREADYSETUPONREADYSETUPOFFREADYHOLDSETUPON6.8AABBNotesMeter default is set for Ready indicator on,and auto endpoint function off.You can also change the Ready indicatorand auto endpoint function in Program P3.1(available from pH mode). Any changesyou make to the Ready indicator/ auto end-point function in conductivity mode willalso change in pH mode.