VarioLink 2650cp Series User’s Guide99USB MenuNote: Factory default settings are shown in bold.Network MenuNote: Factory default settings are shown in bold.Item Settings ExplanationSOFT RESET ENABLEDISABLEEnables or disables the SOFT RESETcommand.SPEED 480Mbps12MbpsSets the maximum transfer speedfor the USB interface.SERIALNUMBERENABLEDISABLEENABLE allows your computer toidentify the printer by its USBinterface serial number.Item Settings ExplanationTCP/IP ENABLEDISABLEEnables or disables this networkprotocol.NETBEUI ENABLEDISABLEEnables or disables this networkprotocol.IP ADDRESSSETAUTOMANUALChange this to Manual to specify the IPaddress through the front panel (seenext entry). Required for non-DHCPnetworks.IP ADDRESS xxx.xxx.xxx.xxxDefault =198.168.100.100Current assigned IP address. Tochange:• Press ENTER.• Use +/– keys to increment firstoctet.• Press ENTER to move on to the nextoctet.• Repeat for each octet.• Press ENTER to register the newaddress.SUBNET MASK xxx.xxx.xxx.xxxDefault =255.255.255.000Current assigned subnet mask. Tochange, proceed as above.GATEWAYADDRESSxxx.xxx.xxx.xxxDefault =192.168.100.254Current assigned gateway address. Tochange, proceed as above.Factory Default [EXECUTE] Initializes the network card.
