3 Using scan functions3-6 cm3521Using scan functions Chapter 3To use a program“Program” refers to the set of destinations and scansettings that are registered together. These areconvenient for frequently sending transmissions withthe same settings.If a destination has not been registered with a program,the destination cannot be specified.The following procedure describes how to send databy selecting a program that has been registered inadvance.% In the Program screen, touch the button for thedesired program.– Touch [Index List] to select the page of programdestinations to be displayed.– To cancel the setting, touch the button again todeselect it.– To clear all of the selected destinations, press the[Reset] key.– To check/delete the specified destination, pressthe [Mode Check] key. For details on checking/deleting destinations, refer to “Checking thesettings (Mode Check)” on page 5-10.
