THERMOSTAT OPERATIONFANWhen the power is connected, the LCD screen on the thermostat will illuminate. Pressingthe FAN button once, will turn on the evaporator fan blower. To turn the blower off, pushthe FAN button once again.COOLING MODE ÄTo operate unit for cooling, push MODE button to display COOL in the window.Push down arrow button multiple times to lower set point to desired temperature.The display will show the set-point temperature for 5 seconds, then it will return to roomtemperature display.After a slight pause, the fan motor and compressor will start, beginning the cooling cycle.Remember, the set-point must be lower than the room temperature for the unit to start.The OUTDOOR and DAY/NIGHT buttons are not used and do not effect unit opera-tion.This is a cooling only thermostat. Select the temperature you want by pressing the ▲ or▼ buttons. The word COOL and the temperature set-point is displayed for 5 seconds.To change display to Celsius, simultaneously press the ▲ and ▼ buttons. Press themagain to change back to Fahrenheit.No batteries are required. In the event of a power failure, when the power is restored thethermostat will continue operating as if the power had never been off.Compressor short cycle protection is built-in to the thermostat. A 4-minute time delay willprotect the unit.MODEFANOUTDOORDAY/NIGHT72WAIT 4 MINUTESBEFORE RE-STARTINGCOOL15