Ocean Signal MOB1 User Manual
Also see for rescureME MOB1: User manualUser manualQuick start guideUser manual
        | |
MOB1 USER MANUAL6 Part No 912S-015172. MOB1 OVERVIEW1) Antenna behind activation slide2) Activation Slide3) Arming Slide (shown in safe position)4) ON Key (for manual activation)5) Strobe and Indicator LED6) TEST/OFF Key7) Arming Slide (in armed position)8) Activation Tape9) Mounting Bracket10) Antenna Rewind Tool11) Programming Adaptor124567MOB1 Controls shownin activated condition10 11398MOB1 USER MANUAL15 Version 01.00 13/02/20157. Appendix7.1 Maintenance and TroubleshootingYour MOB1 will require little maintenance except periodic cleaning, if required. Alwaysuse a damp cloth to clean the case and dry thoroughly. Do not use solvents or othercleaning fluids as this may cause the plastics to deteriorate. Ensure the antenna is free tounwind.7.2 BatteriesThe MOB1 contains Lithium metal batteries for long operating life. Your battery must bereplaced either prior to the expiry date or after the MOB1 has been used, even if onlyactivated for a short period of time. Battery replacement must be carried out at an OceanSignal authorised battery replacement centre.7.3 TransportWhen shipping your MOB1 the following guidance and regulations should be followed, butyou are advised to contact your nearest battery replacement centre or Ocean Signal priorto shipping as regulations may have changed.• Always pack your MOB1 securely in a stout cardboard carton. Ocean Signal advisesthat you keep the original packaging in case of return for service.• For surface transport the MOB1 may be shipped under special provision 188.• For air transport the MOB1 should be shipped as category UN3091 and packed underIATA packing instruction 970 section II. If you are hand carrying your MOB1 on anaircraft please contact you airline for advice.• Consult the manufacturer’s instructions for information on carrying the life jacket onboard aircraft.7.4 DisposalCare should be taken when disposing of your MOB1 when it is no longer required. It isrecommended to remove the battery from the MOB1 by removing the case lid. The casescrews are covered by the top label. Dispose of the battery in accordance with local wasteregulations. Please note that the MOB1 is not user serviceable and opening the casewill invalidate the warranty. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine