Octopus 44364 Installation Manual
                                            | |
Contents
| 
17 of 44Subject to change without notice OC15269 REV Fwww.octopusdrives.comwww.octopuseurope.comB4c Installation• Prepare the steering cylinderi) Use the helm to extend the steeringcylinder to full hard over as shown inFig B19 (it may be necessary to runthe engine to do this).ii) Remove the cotter and clevis pins thatconnect the primary steering cablerod end to the steering cylinder clevisbracket.• Fit the drive collar and spacer bushi) Use the helm to retract the primarysteering cable to full opposite hardover so the rod end disengages fromthe cylinder clevis bracket (Fig B20a).ii) Slacken the clamp screw and lock nuton the fitting kit drive collar.iii) Fit the spacer bush* on to the steeringcylinder sleeve, ensure it is correctlyoriented - refer to Fig B20b.* The spacer bush is not required on Volvomodels 3862513 and 3862514 which were fittedfrom Sept 2003 onwards - the drive collar will clampdirectly onto the cable guide tubeiv) Slide the drive collar on to the steeringcylinder and over the spacer bush asshown in the diagram. Do not tightenthe clamp screw at this stagev) Use the helm to extend the primarysteering cable back to full hard overso that the rod end re-engages intothe cylinder clevis bracket.Fig B19 - Steering cylinder in fully extendedpositionClevisbracketClevispinCotter pinSteering cylinderfully extendedSteering cable fullyretractedSpacerbush*DrivecollarDrive collar &Spacer bush*Steering cable fullyextendedFig B20 - Fitting the drive collar and bush to thesteering cable sleeve |
manualsdatabase
Your AI-powered manual search engine