Oki 5150 User Manual

Also see for C 3200: User guide Service manual

Oki 5150 User Manual Manual pdf 1 page image

Warning!If the printer has recently been powered on, somefuser components will be very hot. Handle the fuserwith extreme care, holding it only by its handle, whichwill only be mildly warm to the touch.A warning label clearly indicates the area. If in doubt,switch the printer off and wait at least 10 minutesfor the fuser to cool before opening the printer cover.1. Press the cover release and open the printer's top cover fully.2. Note the positions of the four image drums: Cyan (1), Magenta (2), Yellow (3),Black (4). It is essential that they go back in the correct order!3. Lift each of the image drum units out of the printer and place them in a safeplace4. Locate the two blue locks (1) and the handle (2).5. Turn the two locks about 45 degrees counterclockwise to release the belt.6. Pull up the handle and lift the belt unit out of the printer.7. Unpack the new belt unit and hold it with the blue handle toward the front ofthe printer.8. Place the drive gear at the back of the belt unit in the gear at the left rearcorner of the printer, and lower the belt unit into the printer.Belt Replacement for Oki 42158711C3200/5150/C5200/C5400 PrintersBelt Instructions

/ 2

Related manuals for Oki C 3200