Oki C301 User Manual

Also see for C301: Maintenance manual

Contents

Oki C301 User Manual Manual pdf 48 page image

Menu functions > 48PCL EMULATIONThis menu controls settings effective when the printer is operating in PCL emulation mode.WAIT TIMEOUT 5~40 SEC~300, OFF Specifies how many seconds the printer will wait whenreceived data pauses before forcing a page eject. InPostScript Emulation mode the job will be cancelled iftimeout occurs.LOW TONER CONTINUESTOPSpecifies whether the printer should continue printingeven after a low toner condition is detected.JAM RECOVERY ONOFFSpecifies whether the printer should perform jamrecovery after a paper jam has occurred. If ON, theprinter will attempt to re-print any pages lost due to apaper jam once the jam has been cleared.ERROR REPORT ONOFFIf ON, the printer will print error details when aPostScript Emulation error occurs.Note: Applies tp PS & PCL XL only.ITEMS SETTINGS EXPLANATIONFONT SOURCE RESIDENT /RESIDENT2Specifies the location of the PCL default font. Normallythis will be INTERNAL unless additional fonts areinstalled in the expansion ROM slot or additional fontshave been downloaded to RAM as permanent fonts.FONT NO. I0 ~ I90 Sets the current default font number from the currentlyselected source.FONT PITCH 0.44CPI~10.00CPI~99.99CPISets the width of the PCL default font in characters/inch(CPI).Default font is the fixed-pitch, scalable font. The value isdisplayed to the second decimal placeDisplayed only when the font selected in Font No. isfixed-spacing, scalable font.FONT HEIGHT 4.00 POINT~12.00POINT~999.75 POINTHeight of the PCL default font.Note: This menu item is displayed only when the fontselected in Font No. is a proportional-spacing, scalablefont.SYMBOL SET PC-8(Default Symbol Setonly shown)PCL symbol set. If the font source and number arechanged to one which does not support the selectedsymbol set, this must be changed to an availablesymbol set for that font.A4 PRINT WIDTH 78 COLUMN80 COLUMNSets the number of columns subject to Auto LF with A4paper in PCL. This is the value when Auto CR/LF Mode isset to OFF with the 10CPI character.WHITE PAGE SKIP OFF / ON Selects whether blank pages are printed or not.CR FUNCTION CR / CR+LF Selects whether a received carriage return character(0Dh) also causes a line feed.LF FUNCTION LF / LF+CR Selects whether a received line feed character (0Ah)also causes a carriage return.PRINT MARGIN NORMAL1/5 INCH1/6 INCHSets the non-printable page area. NORMAL is PCLcompatible.TRUE BLACK OFF / ON Selects whether black image data is printed using blacktoner (ON) or 100% CMY (OFF). (Valid in PCL emulationmode only.)ITEMS SETTINGS EXPLANATION