41316401TH Rev.4 119 /Note! The life information on the belt, toner, IDs etc. is cleared due to replacement of theEEPROM. Take note that an error occurs in the each unit’s life count until the unit isreplaced. Following is counts cleared after the replacement of the EEPROM.Counts except the count Total Sheets Feed are cleared upon replacement of the units,respectively, where errors are corrected.4.2.3 EEPROM replacement after CRM board replacementTo replace the CRM board, remove the EEPROM on the board and include the EEPROM on anewly installed board (to allow a new board to inherit user-defined settings and font installationinformation).When the user’s EEPROM is unusable due to its problem, use the new one on the new board,where the destination of the new board must be set. See Section 4.1.3 “CRM board adjustments”for the setting procedure.ItemFuserTransfer BeltBlack Imaging DrumCyan Imaging DrumMagenta Imaging DrumYellow Imaging DrumBlack TonerCyan TonerMagenta TonerYellow TonerTotal Sheets FeedBlack ImpressionsCyan ImpressionsMagenta ImpressionsYellow ImpressionsCountFuser LifeTransfer Belt LifeEach Imaging Drum LifeToner ConsumptionPrinter LifeTotal Number of PagesPrintedDescription of CountA value in letter paper sheets converted from the number ofsheets fed after the installation of a new fuser unit.A value in letter paper sheets converted from the number ofsheets fed after the installation of a new belt unit.A value in letter paper sheets converted from theinstallation of a new ID unit.The number of dots printed.The total number of pages printed.The number of pages printed after the installation of a newID unit.
