C8800 User’s Guide111Network MenuThis menu controls the operation of the printer’s 10Base-T/100Base-TX network interface.Notes:Factory default settings are shown in bold.Settings with a dagger (†) only appear when theappropriate option is installed.Item Settings ExplanationTCP/IP ENABLE /DISABLEEnables or disables this networkprotocol.IP VERSION IP V4 / IPV 4 &V6NETBEUI ENABLE /DISABLEEnables or disables this networkprotocol.NETWARE ENABLE /DISABLEEnables or disables this networkprotocol.ETHERTALK ENABLE /DISABLEEnables or disables this networkprotocol.FRAME TYPE AUTO / 802.2 /802.3 /ETHERNET II /SNAPSelects the Ethernet MAC layer frametype.IP ADDRESSSETAUTO /MANUALSpecifies whether IP address allocationis automatic (DHCP) or manuallyassigned.IP ADDRESS xxx.xxx.xxx.xxx Current assigned IP address. Tochange, press ENTER and use +/–keys to increment 1st octet, then pressENTER again to move on to next octet.When 4th octet has been set, pressENTER again to register new address.SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. Tochange, proceed as above.GATEWAYADDRESSxxx.xxx.xxx.xxx Current assigned gateway address. Tochange, proceed as above.FACTORYDEFAULTSEXECUTE Reloads the settings present when theunit was setup by the manufacturer.WEB ENABLE /DISABLEEnables or disables Web config. facility.
