Printing from UNIX: Configuring the Print Server • 182Printing from UNIX:Configuring the Print ServerThe first step in installing the network card under UNIX is to set upthe IP address, Subnet Mask and Gateway. This section explainsone way to set them up from a UNIX workstation.• The network addresses used in this manual are shown asexamples only. Network addresses used in your installation mustbe generated for your own network.• Log in as [root] to change the configuration of the Print Server. Bydefault, there is no root password.The following explanation uses Sun Solaris 2.8 (Solaris 8) as anexample. The actual commands may differ between versions ofUNIX, so refer to the workstation manuals for more information.1. Log in as root to the workstation.If you do not have superuser rights, the network manger shouldconduct the configuration.2. If the print server does not have an IP addresses alreadyassigned, use the arp command to set a temporary IP address.ExampleFor IP address 172.68.20.127 and network card address00:80:92:01:00:D2:# arp –s 172.168.20.127 00:80:92:01:00:D2 tempImportant!If an incorrect IP address, Subnet Mask or Gateway is entered,the network may go down or other damage may occur. Checkthe address with your network manager.
