Rev. 1.0 - 21 -LD630D/LD640D5-2 Stand-alone Configuration ModeVarious modes can be executed using buttons and LED only.5-2-1 How to start stand-alone configuration mode• The printer mode is set to Printer Setting Mode when the Pause button is depressedfor two seconds while in Print Standby Mode.• Both LEDs will change to orange color and the printer will be set to Stand-aloneConfiguration Mode.• When the printer enters into this mode, the status of Status LED and Error LEDare changed sequentially.• When the Feed button is depressed at specific LED color combination, thecorresponding printer operation will be selected.5-2-2 List of supported functionsSequencenumberStatus LED Error LED Printer operationColor Status Color Status1Green OnGreen Blink four times Print Configuration Info.2 Orange Blink four times Print File List3 Red Blink four times Factory Reset4Orange OnGreen Blink four times Gap Sensor Auto Calibration5 Orange Blink four times B/M Sensor Auto Calibration6 Red Blink four times Data Dump Mode7Red OnGreen Blink four times Demo Mode8 Orange Blink four times -9 Red Blink four times Object Delete