Oki MC-860 / CX2633MFP Service & Troubleshooting Manual

Also see for MC-860 / CX2633MFP: Maintenance manual

Oki MC-860 / CX2633MFP Service & Troubleshooting Manual Manual pdf 43 page image

Printed Sheets Counter DisplayThis self-diagnostic menu is used to display the number of printed sheets status of the MFP.1. Enter the self-diagnostic mode and press the (2) key or (8) key until[PRINTER STATUS] is displayed on the screen.Press the (6) key to execute.The (2) key increments the test item and (8) key decrements the test item.2. When the (2) key or (8) key is pressed, number status of the printed sheets aredisplayed in order. Pressing the (*) key or the (#) key is invalid.When the (4) key is pressed, the screen exits the test. (Screen returns to the item 1condition.)Display Unit of Measure DetailsK – IMPRESSIONS ImagesY – IMPRESSIONS ImagesM – IMPRESSIONS ImagesC – IMPRESSIONS ImagesNumber of printed sheets for eachcolor are displayed.TOTAL SHEET CNT Prints Total number of printed sheetsare displayed.2.7.7 Factory/Shipping Mode SwitchingThis self-diagnostic menu is used to switch the PU PCB from the Factor mode to theShipping mode.1. Enter the self-diagnostic mode (Level 1) and press the (2) key or (8) key until thefollowing message is displayed.2. When the (6) key is pressed, the following message is displayed.Press the (2) key or (8) key until the desired item (refer to the table below) is displayed.3. While desired item to set is being displayed, press the (6) key to enable operator toselect the setting value.4. While desired item to set is being displayed, press the (6) key for an extended time (3seconds) to register the display value in EEPROM. Screen returns to the item 2condition.When the (4) key is pressed, the screen exits the test. (Screen returns to the item 1condition.)43