Oki MICROLINE 320 Turbo Handbook

Also see for Microline 320 Turbo D1: User guide Brochure & specs Product update User guide User guide

Contents

72 Appendix B: Menu SelectionsExplanation of Menu ItemsThese explanations are in alphabetical sequence to make it easier to look them up.Many of the items will appear only with optional equipment installed, as noted be-low. You will find the items Line Spacing, Form Tear-Off, Skip Over Perforation andPage Length appearing several times in the menu (once for each paper path).7 or 8 Bit Graphics. Choose 7 (factory default) or 8 bits.7 or 8 Bit Data word. Choose 8 (factory default) or 7 bits.Auto CR. IBM mode only. No (factory default) or Yes. Choose Yes to make your printerautomatically perform a carriage return when a LF is received at the end of the line.Auto LF. No (factory default) or Yes. Change to Yes if your printer overprints. Keepthis set to No if your software adds a line feed when a carriage is received at the endof a line. If your printout is consistently double spaced, set this item to No.Auto Select. No (factory default) or Yes. Determines whether or not your printer willautomatically be selected after you load in paper. With the factory default (No) en-gaged, the printer will be deselected so that you can set the Top of Form. If you al-ways use the same Top of Form setting, change this setting to Yes so that you don’thave to press the SEL button to select the printer after loading paper.Auto Feed XT. Epson mode only. Invalid (factory default) or Valid. In the Epson emu-lation, the XT signal on pin 14 of the parallel interface can control automatic line feed.Some interface cables are wired in such a way that automatic line feed is always ineffect: the Auto Feed XT item eliminates this potential problem. The factory settingcauses the printer to ignore this signal; if your system uses pin 14 to control automaticline feed, change the setting to Valid.Baud rate. Appears only if optional Serial Interface is installed. Range from 19,200 to300 bps: factory setting, 9600 bps. This item sets the transmission rate for the system.Bottom Margin. Valid (factory default) or Invalid. Sets whether or not the printer willignore the bottom margin setting. Change the setting to Invalid if you want printer toignore the bottom margin setting. Be careful if you use this feature: it lets the printercontinue printing when there’s no more paper, which can cause loss of data and maydamage the printhead.