21 Unpack your machine.! Keep your packing materials and carton in case you everneed to ship or transport the unit.2 Remove the shipping restraints and tape.32T-17.eps, 32T-16.eps, 32T-07A.eps and arrows.epsQUIETPARKTEARFF/LOADLFSELSELPOWER ALARM MENUGROUPEXIT ITEM SET PRINTMENU SHIFTTOFMicro FeedUpMicro FeedDownPRINT QUALITYCHARACTER PITCHHSDNLQUTLSSD10 12 1517 20 PROPQUIETPARKTEARFF/LOADLFMENUUP ITEM SET PRINTTOFMicro FeedUpcro FeedownPRINT QUALITYCHARACTER PITCHHSDNLQUTLSSD10 12 1517 20 PROP3 Install the ribbon.4 Install any accessories you purchased. Refer to theinstructions provided with each accessory.5 Connect to the power outlet.Paper Loading! To load single sheets, see your Printer User’s Guide,“Installation, Paper Loading.”To load bottom-feed paper, see the instructions providedwith the pull/push tractors.To load rear-feed, continuous-forms paper:1 Grasp the tabs and lift off the paper separator.32T-23A.eps1 Physical Setup2 Load the paper on the tractors. Install the paper separator.32T-29.eps and 32T-23A.eps3 Place the wire guide (1) on the pull-up roller assembly (2).Then, press FF/LOAD.32T-31.epsTesting the PrinterRun the Font Sample Test to make sure your printer is operatingproperly.! Wide Carriage ModelMicroline 321 Turbo/nIf you are using 8.5 inch paper to run the test, make surethe paper width selection in the printer menu is set to 8.5inches. Otherwise, printing on the platen may damage theprinter. Refer to the Printer User’s Guide, “Using YourPrinter, Menu Mode, Explanations of Menu Items.”To run the test:• Turn the printer off, then press and hold the LF key whileturning the printer back on.To stop the test before it is finished:• Press SEL.1 2