Oki Microline 490 User Manual

Also see for Microline 490: Setup guide Specifications Guía del usuario Guide de l'utilisateur Manual do usuário

Contents

Oki Microline 490 User Manual Manual pdf 35 page image

Menu Mode 35Explanations of Menu ItemsThese explanations are in alphabetical sequence to make iteasier to look them up. Some items only appear when optionalaccessories are installed; others appear in several groups in themenu.Auto CR, Default =NoIBM Only. If you want the printer to automatically add acarriage return when a Line Feed is received at the end of aline, change the setting to Yes.Auto LF, Default = NoIf your printout is consistently double spaced, select No; if itoverprints, select Yes.Auto Feed XT, Default = InvalidEpson Only. In the Epson emulation, the XT signal on pin 14 ofthe parallel interface can control automatic line feed. Someinterface cables are wired in such a way that automatic linefeed is always in effect: this item eliminates this potentialproblem. If your system uses pin 14 of the parallel interface tocontrol automatic line feed, change the setting to Valid.Auto Select, Default = NoDetermines whether or not your printer will automatically beselected after you load in paper. With the factory defaultengaged, the printer will be deselected so that you can set theTop of Form. If you always use the same Top of Form position,change the setting to Yes.Bi-direction, Default = EnableChange this setting if you wish to disable bidirectionaltransmission (PnP) in Nibble mode.Bottom Margin, Default = ValidChange to Invalid if you want the printer to ignore the bottommargin setting.CAUTION!!Setting the Bottom Margin to Invalid can cause loss of dataand damage the printhead by allowing printing without paper.