40718301TH Rev.6 78 /4.1.4 EEPROM initializationThe corresponding are of the EEPROM is initialized for each event as shown Table 4-1.Talbe 4-1 EEPROM Initial Setting RangeEEPROM areaNo EventMenu level 1Menu level 2F/W revision areaCustomer informationUser maintenance areaNote1)System maintenance areaNote1)Engine maintenance areaNote1)Drum counterFuser counterPage counter: Represents initializationNote1) Items of each maintenance menu which are subjects here are listed in the following table.Note2) Only when the page counter is 500 sheets or less, it is reset to 0.1234567User maintenancemenu resetSystem maintenanceEEPROM resetEngine maintenanceengine resetFirm revision checkerror at power-onEngine ID checkerror at power-onCustomer settingUser informationerrorNote2) Note2)Talbe 4-1 Items of Each Maintenance Menu Targeted for EEPROM ResetUser maintenance menu areaResource saveReceiving bufferOperator panel menu functionenable/disableX/Y ADJUST2ND feed destinationdesignating commandLeft alignment based printing shiftCleaning cycleTransfer current(Only Engine ID check error atpower on Event)System maintenance menu areaWhether a page counter printing isadded or not to a menu printingSIDM emulation switchenable/disableEngine maintenance menu areaLED head drive time(excluding during engine reset in engine maintenance)Adjusting head type(excluding during engine reset in engine maintenance)600 × 1200DPI strobe time relative value(excluding during engine reset in engine maintenance)Installed LED head identification(excluding during engine reset in engine maintenance)Print start positionPaper feed amount from each paper feed trayEach optional tray motor controlling parameterEngine test