41260201TH Draft 75 / 1061 An image is light or blurred entirely.• Is the toner low? (Is "Toner Low" being displayed?)• Yes Supply a toner.• No Is the specified paper being used?• No Use the specified paper.• Yes Is the lens of the LED head dirty?• Yes Clean the LED head.• No Is the LED head installed correctly?Check the HEAD1, HEAD2 connector of the main control board.• No Install the LED head correctly.• Yes Is the contact plate of the transfer roller in correct contact with the high-voltage powersupply board(P2H)? (See Figure 6-4 F .)• Yes Is the terminal of the I/D unit in correct contact with the contact plate? (See Figure 6-4 A and B )?• No Contact the terminal correctly.• Yes Replace the transfer roller.• Has this error been recovered?• Yes End• No Replace the I/D unit.• Has this error been recovered?• Yes EndCaution: After replacing the I/D unit, reset the drum counter. (Refer to"Replacing the Drum Cartridge" in "User's Manual".)• No Replace the main control board, high-voltage power supply board(P6L) or high-voltagepower supply board(P2H).
