Oki RS232-C Installation Instructions Manual

Also see for B4200: User manual Instructions Installation instructions Setup guide User guide

Oki RS232-C Installation Instructions Manual Manual pdf 1 page image

RS232-C SerialInterface CardInstallation InstructionsRS232-C Serial Interface Card Part Number: 70042701Oki Data Americas, Inc., Mt. Laurel, NJ 08054http://www.okidata.com1. Unpack the serial card andremove any shipping materials.2. Turn off the printer and removethe power cord and interfacecable.3. Remove the access panel screw.4. Lift off the access panel.5. Install the Serial Interface Card:a. Align the connector at thebottom of the card with theconnector on the main board. Ithelps to align the screw holes (1)to position the card correctly.b. Press the card down until theconnectors are fully engagedand the card is securelyinstalled.6. Insert and tighten the screws (1).7. Replace the access panel:a. Snap off the breakout tab.b. Align tabs at panel bottom withholes in printer frame.c. Swing panel up and into place.d. Replace the screw.8. Verify Installation:Print a MenuMap-a. Press the Menu button one ormore times until INFO.MENUappears on the display.b. Press SELECT twice. TheMenuMap prints.c. RS232C MENU should appearin the second column. If it isn’tthere, check to be sure that thecard is installed correctly.To change RS232-C settings:See the User’s Guide on the CDincluded with your printer forinstructions to select interfacesettings in the printer Menu.58366401

/ 1

Related manuals for Oki B4200