Olivetti Copia 9910 Operation Manual

Contents

Olivetti Copia 9910 Operation Manual Manual pdf 54 page image

D GB1 – 32STATUS INDICATORSWhen the following indicators light up or blink on the operation panel or the following symbols appear in thedisplay, solve the problem immediately referring to both the table below and the relevant page.IndicationDrum replacementrequired indicatorTD cartridge replace-ment required indicatorMisfeed indicatorSPF misfeed indicatorThe paper trayindicator is blinking.„CH“ is blinking inthe display.„CH“ is steadily lit in thedisplay.„P“ is blinking inthe display.A letter and a numberappear alternately.Cause and remedyReplacement of drum cartridge will be needed soon. Preparea new cartridge. p. 1-23Drum cartridge must be replaced. Replace it with a new one.p. 1-23Replacement of TD cartridge will be needed soon. Prepare anew cartridge. p. 1-21TD cartridge must be replaced. Replace it with a new one.p. 1-21A misfeed has occurred. Remove the misfed paper referring tothe description of „Misfeed removal.“ p. 1-26. Lever of fusingarea is not raised. p. 1-27. Depending on your model, the lowerside cover may be open. If so, close it. p. 1-28.An original misfeed has occurred in the SPF. Remove the misfedoriginals referring to the description of "Misfeed in the SPF".p. 1-29.The paper tray is not installed properly. Push the tray into thecopier securely. p.1-8.The TD cartridge is not installed. Check if the cartridge is instal-led. p. 1-7Side cover is open. Close the side cover securely by pressingthe round projections near the side cover open button. p. 1-7Paper tray or bypass tray is empty. Load copy paper. p. 1-8A misfeed has occurred in the paper tray or bypass tray.Remove the misfed paper. p. 1-26Paper tray is not securely installed. Push the tray in securely.p. 1-8, 1-16The copier will not function. Turn the power switch off andthen switch it on, and if there is again an error, remove thepower cord from the outlet, and contact your authorized Ser-vice representative p. 1-4.SteadilylitBlinkingSteadilylitBlinkingBlinkingBlinkingwstQnBe sure to use only genuine parts andsupplies.Use the following procedure to display the total number of copies.DISPLAYING TOTAL NUMBER OF COPIES1. Press the clear (>) key to reset thedisplay to zero.2. Press and hold down the clear (>)key for approximately 5 seconds. Thetotal number of copies will appear intwo steps, each with three digits.Example:Total number of copies is 1,234.2nd_part_d_gb.p65 24/05/99, 13.2332