5-8 XYAA63381Fig. 5-4Fig. 5-55.5 REMOVING THE PRINT HEAD• Remove the case (Section 5-2).• Remove screw 1.• Remove the two boards to which the power supplyflat cable is connected as shown in Figure 5-4.• Proceed as explained in Section 5.3 to access theelectronic board and therefore disconnect the flatcable from connector J7 on this board.• To completely extract the print head and related flatcable remove the board shown in Figure 5-14;gently bend this board so that it can be removed.• To reassemble follow the disassembly procedurein reverse order.Note: After replacing the head readjust the parallelismand the distance between the print head andplaten (Section 6.2)
