18 19123451. Keep the MODE button presseduntil the “year” indicator startsblinking.Be sure to correct the date and time after the batteries havebeen inserted or replaced.2. Press the SET button to adjust the“year” indicator. If you press thebutton once, the number on thedisplay will advance by 1. If youkeep the button pressed, thenumbers will run in rapidsuccession. If you pass theintended number, keep pressing toreturn to that number.3. Press the MODE button once moreto make the “month” indicatorblink. Press the SET button toadjust the “month” indicator. Asyou press the MODE button, theblinking indicator changes in theorder of “year”, “month”, “day”,“hour” and “minute”.4. Repeat Steps 2 and 3 to set “hour”and “minute”. Make sure the“minute” indicator is blinking.5. When “minute” has been set, pressthe MODE button. None of theindicators will be blinking and date/time correction is now complete.CORRECTING THE DATE AND TIME(Quartzdate models only)123REMOTE CONTROLRC-300C1. Turn the screw on the bottom of theremote control counterclockwise toloosen.If the selftimer/remote control indicator doesn’t blink evenwhen you press the button, replace the battery with a newone (CR2025).How to replace the battery of the remote control (RC-300C)2. Turn the remote control over, andremove the cover. With the batteryfacing up, remove the old batteryand insert a new battery as shown.3. Replace the cover, turn the remotecontrol over, and turn the screw onthe bottom clockwise to tighten.RC-300C (Optional)