Olympus DM-20 Online Instructions Manual

Also see for VOICE & MUSIC DM-10: Installation guide Instructions Instructions Instrucciones en Línea Mode d'emploi

Contents

915HoldHoldSetting the HOLD switch to the HOLD position.If you set the recorder to HOLD status by slidingthe HOLD switch in the direction of the arrow, thecurrent conditions will be preserved, and all buttonsand switches except the HOLD switch will bedisabled. This feature is useful when the recorderhas to be carried in a bag or pocket.Remember to reset the HOLD switch when usingthe recorder.Running state when HOLD is set2OnOnOffOnOnOff1STOPSRunning3NotconnectedOffOnNotconnectedOffOn4The display goes out after “HOLD”blinks for 2 seconds.*1The display goes out after “HOLD”blinks for 2 seconds.*1Normal operationIf HOLD is applied during playback(recording), operation is disabled with theplayback (recording) state unchanged.*2If HOLD is applied during playback(recording), operation is disabled with theplayback (recording) state unchanged.*2Normal operation5Normal operation. If the recorderstops after button operation, thedisplay goes out 20 seconds later.Button operation on the remote controlleris invalid.Normal operation. If the recorderstops after button operation, thedisplay goes out 20 seconds later.Button operation on the remote controlleris invalid. However, the REC lamp is litwhile the recorder is recording.*1: Pressing any button makes clock display blink for 2 seconds but the recorder does not start.*2: The recorder stops when playback completes or recording terminates due to no memory space.NoteThe alarm will sound at the scheduled time even if the recorder is set to hold. The recorder begins to play thefile associated with the alarm when you press any button.1: State of the recorder, 2: HOLD of the recorder, 3: HOLD of the remote controller, 4: Buttonoperation on the recorder, 5: Button operation on remote controller