EN 35ENQ5: How should the Case be handled after use?A5: After use, take out the camera as soon as possible and wash theCase with pure water. In case of use in the ocean, it is effective toimmerse the Case for a certain time in pure water to remove anysalt. Operate the buttons and levers under water to turn the shaftsand wash off any salt. After washing, use a dry cloth without anysalt on it to wipe off any moisture and dry the Case in the shade.Do not use hot air from a hair dryer or the like and do not dry theCase under direct sunlight. Exposure to high temperature or directsunlight may cause deformation, discoloration or breakage of theCase and deterioration of the O-ring. Wipe the inside of the Casewith a soft cloth not causing any fibers. Remove the O-ring, wipeoff any salt, sand, dust, etc., and also clean the O-ring groove andthe O-ring contact surface in the same way and then dry them.When an object with a sharp tip is used to remove the O-ring fromthe groove, the O-ring may be damaged and water leakage mayoccur. Always use the O-ring remover provided.Q6: How should I take pictures under water?A6: Please observe the following items for shooting under water.1 Fix the protector with the hand strap provided to your wrist.2 When you place a finger onto the lens window, the finger will appearin the photo. Pay attention to the position of your fingers whenholding the Case.3 Hold the Case securely with both hands and press the shutterbutton gently to prevent camera shake.4 Check the image you want to shoot by viewing the digital camera’sLCD monitor through the Case’s LCD monitor window, and startshooting. In order to avoid losing shutter chances due to anexhausted battery, you should always replace a battery with a fullycharged battery before each dive.
