Olympus Stylus 1030SW Instruction Manual

Also see for Li-50B - Stylus 1030 SW 10.1MP Digital Camera: Basic Manual Manual de instrucciones Manual Instructions

Olympus Stylus 1030SW Instruction Manual Manual pdf 51 page image

EN 51Getting to know your camera betterGetting to know your camera betterThe direction of the battery is incorrect• Insert the battery in the correct direction.The battery is not fully charged• Charge the battery with the charger.The battery is temporarily unable to function because of the cold• Battery performance declines in low temperatures, and the charge may not be sufficient toturn on the camera. Remove the battery and warm it by putting it in your pocket for a while.• If the card’s contact area is dirty, the [CARD SETUP] screen may display without readingthe card. In this case, select [CLEAN CARD], and press o. Then, remove the card and wipethe contact area with a soft, dry cloth.The camera is in sleep mode• To save battery power, the camera automatically goes into sleep mode and the monitorturns off if there is no operation after 3 minutes when the camera is turned on (when the lenscover is open and the monitor is on). No picture is taken even if the shutter button is fullypressed in this mode. Operate the zoom button or other buttons to restore the camera fromsleep mode before taking a picture. If the camera is left on for 15 minutes, it automaticallyturns off (the lens cover closes and the monitor turns off). Press o to turn the cameraon.The mode dial is set to q or P• This is the playback mode for displaying pictures on the monitor. Set the mode dial to ashooting mode.The mode dial is in the position of g• No pictures can be taken when the shooting guide is being displayed. Take pictures afterselecting your desired shooting effect in the shooting guide or set it to a setting other thang in shooting mode.The flash is charging• Wait until the # (flash charge) mark stops blinking before taking the picture.The camera has been used in the same conditions from the time of purchase• No date and time have been set for the camera at the time of purchase. Set the date andtime before using the camera.g “Turn the camera on” (P. 6)“X Setting the date and time” (P. 37)The battery has been pulled out of the camera• The date and time settings will be returned to the factory default settings if the camera is leftwithout battery for approximately 1 day. Also, the date and time setting will be canceledearlier than this if the battery has been in the camera for a short period of time. Before takingimportant pictures, check that the date and time settings are correct.Shooting tips and informationTips before you start taking picturesThe camera does not turn on even when a battery is loadedCannot use the cardNo picture is taken when the shutter button is pressedThe date and time have not been set