Olympus Stylus m790SW Instruction Manual

Also see for 226090 - Stylus 790 SW Digital Camera: Manual Avanzado Manuel Avancé Manual de instruções

52 ENGetting to know your camera betterGetting to know your camera betterThe battery is not fully charged• Charge the battery with the charger.The battery is temporarily unable to function because of the cold• Battery performance declines in low temperatures, and the charge may not be sufficient toturn on the camera. Remove the battery and warm it by putting it in your pocket for a while.• If the card’s contact area is dirty, the [CARD SETUP] screen may display without readingthe card. In this case, select [xD CARD CLEAN], and press o. Then, remove the card andwipe the contact area with a soft, dry cloth.The camera is in sleep mode• To save battery power, the camera automatically goes into sleep mode and the monitorturns off if there is no operation after 3 minutes when the camera is turned on (when the lenscover is open and the monitor is on). No picture is taken even if the shutter button is fullypressed in this mode. Operate the zoom button or other buttons to restore the camera fromsleep mode before taking a picture. If the camera is left for 15 minutes, it automatically turnsoff (the lens cover closes and the monitor turns off). Press o to turn the camera on.The mode dial is set to q or P• This is the playback mode for displaying pictures on the monitor. Set the mode dial to ashooting mode.The mode dial is in the position of g• No pictures can be taken when the shooting guide is being displayed. Take pictures afterselecting your desired shooting effect in the shooting guide or set it to a setting other thang in shooting mode.The flash is charging• Wait until the # (flash charge) mark stops blinking before taking the picture.The memory gauge is full• No pictures can be taken when the memory gauge is full. Wait until there is space in thememory gauge.The camera has been used in the same conditions from the time of purchase• No date and time have been set for the camera at the time of purchase. Set the date andtime before using the camera.g “Turn the camera on” (P. 6)“X Setting the date and time” (P. 35)Shooting tips and informationTips before you start taking picturesThe camera does not turn on even when a battery is loadedCannot use the cardNo picture is taken when the shutter button is pressedThe date and time have not been seta b c dBefore taking anypictures(Off)Maximumreached(All lit)After taking onepicture(Lit)After taking severalpictures(Lit)Shoot Shoot ShootWait