Omcan CE-CN-0082T-WG Instruction Manual

17OperationAny alteration of the product may be potentially hazardous. Use only low pressure flexible pipes and regulatorsallowed by the current regulation. To replace the pressure regulators and flexible pipes please refer only tothe manufacturer instructions. Check hose each time before using the oven for nicks, cracking, abrasions orcuts. If the hose is found to be damaged in any way,do not use the oven. Move the oven door holding the woodhandles.LIGHTINGCheck all gas connections for gas leak before starting your oven. Do not lean over the oven when lighting.Keep your face and body at least 50 em /19,6 inches far from the oven door. When lighting the oven, the ovendoor must be open. The burner control knob must be in the off position before turning on the LGP cylindervalve.1. Make sure burner knobs are turned to OFF.2. For gas oven using a propane tank. Slowly open the tank valve.Note: if flow limiting device activates, your oven may not light. If your oven does not light, the flames will below and will not heat properly. Turn tank valve and burner knob off and wait 30 seconds. After shutting offthe tank, very slowly open tank valve and wait 5 seconds before lighting.3. Push the pulse ignitor module,push in and turn the burner knob to IGNITE/HI for the burner. The burner willlight immediately. When burner is lit, turn knob to desired setting.- If the flame does not light, leave the knob turning it to “off position”. Wait 5 minutes and try again.- Do not keep on oven at the maximum power more than 20 minutes.- Do not exceed the limit temperature of 426°C / 800°F.- During operation, never disconnect the gas regulator or other junctions.- Do not touch external surfaces and the chimney flue during oven operation.TO LIGHT THE GRILL WITH MATCHIf a burner will not light after several attempts using the control knobs, the burners may be lit with a Match.1. If you have already attempted to light the main burner with the igniter, allow 5 minutes for any accumulatedgas to dissipate.2. Insert a match into the lighting rod.3. Strike the match to light it.4. Gently hold the lit match close to the burner5. Push the pulse ignitor module and push in and turn the control knob to IGNITE/ON. Hold this knob in for15 seconds after the burner is lit. You will hear the “snapping” sound of the spark until after the knob isreleased.6. Remove the match and replace the manual lighting extension inside the cabinet door.7. If the burner does not light within seconds turn the knob to the “OFF” position, wait 5 minutes and try again.CAUTIONWhen using a match to light the grill make sure to use the attached lighting rod.WARNINGBefore lighting, please check the connection with proper procedure if leak turn the gas off.