Omcan FW-CN-1800 Instruction Manual

Contents

6Operation1. Plug the unit into a grounded outlet.2. Open the tank cover and make sure that the filter inside the tank is properly installed.3. Fill the unit up with approximately 3 quarts of cold tap water (Do not overfill the tank). This unit is designedto be used with cold tap water. Distilled water may be used to reduce calcium/mineral deposit build-up.4. Turn the on/off switch to the on position and allow for the unit to preheat for 25 minutes.5. Once heated, open the top cover and place food items into the basket(half size perforated food panincluded) and then close the top cover.6. Press the steam button for 2 seconds and release and wait 20 seconds for the steam to penetrate theitems inside the unit. Repeat if product requires more steam.PLEASE NOTE THAT PRESSING AND HOLDING THE STEAM BUTTON FOR LONGER THAN 2SECONDS AT A TIME WILL OFTEN FLOOD OUT AND RESULT IN POOR STEAMING.7. Remove the hot, steamed product from the unit.8. Turn unit power switch to off if finished using.WARNING: THE EXTERIOR OF THE UNIT GETS HOT WHILE IN USE!Technical SpecificationsInstallationModel FW-CN-1800Capacity 1/2 GNMaterial Stainless SteelPower 1800WElectrical 120V / 60Hz / 1Dimensions 16.5” x 15” x 7.9” / 420 x 380 x 200mmItem Number 444071. Remove all packing materials both inside and outside the unit and place on a flat surface.2. Clean machine thoroughly before first use.3. Position unit near a power outlet. It is not recommended to use an extension cord for this item.4. Do not place in an area where gasoline, paint or flammable liquids are used or stored.5. Unit must be used operated with the legs installed.