7InstallationOperationMOVING THE MACHINEATTENTION!Lift the machine with a forklift of suitable capacity. Check the stability and positioning of the weight on theforks, especially along uneven, slippery or inclined paths. When moving the machine keep the load as low aspossible to guarantee greater stability and visibility. Stabilize the grip by widening the forks of the forklift.CONNECTION TO THE ELECTRICAL SYSTEMATTENTION!Make sure the electrical source corresponds to the value reported on the identification plate of the machine.Each operation should be carried out only by specialized personnel authorized by the appropriate supervisor.Connect the machine to a network with an efficient floor plug.Connect the cable to the 230 V/50 Hz single-phase electrical supply network, inserting a 16-Ampmagnetothermic differential switch. For machines with voltages different from those mentioned consult themanufacturer. If the feeding cable needs to be extended, use a cable with the same section as the onesupplied by the manufacturer.LIST OF COMMANDS1. Stop pushbutton.- Stop pushbutton: black color.- Press to stop the machine.- The led on the pushbutton lightsup only when the stop pushbutton ispressed (4).2. Start pushbutton.- Start pushbutton: gray color.- Press to start the machine.3. Lit indicator of connection to themains.- White color.- It indicates the connection of themachine to the network.START UP AND STOPATTENTION!Check that the feeding line corresponds to the value reported on the identification plate of the machine and