PAC RB10GM14B Manual

PAC RB10GM14B Manual Manual pdf 1 page image

Stinger HEIGH10 Radio Replacement Kitfor select 2014-2019 Silverado/Sierra TruckRB10GM14B© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.Pacific Accessory CorporationPage 1Rev: V 1Date: 030121®®Introduction and FeaturesThe RB10GM14B is a complete radio replacement kit for the installation of the Stinger HEIGH10® modular radio inChevrolet Silverado and GMC Sierra trucks. All modules, cables and adapters are included to retain important features of thefactory system, including: OnStar, front and rear park assist, warning chimes, factory reverse camera, steering wheel-mountedradio controls and AM/FM reception. Plug & Play wiring harnesses allow for quick and easy installation without the need to cutor splice any wiring. The display mounting panel allows flush mounting the 10 inch display without modifying/cutting any part ofthe vehicle’s sub-dash.Important NotesRecommended ToolsWe recommend reading this manual thoroughly to familiarize yourselfwith the entire process prior to beginning the installation.1. HEIGH10 Display Mounting Panel2. Dual USB Extension (SSUSB2)3. AM / FM Antenna Adapter (BAA22)4. Satellite Antenna Adapter (SAT-01)5. Main Harness (SR-GM14H-HAR-A)6. Vehicle Side Harness B (SR-GM14H-HAR-B)7. Vehicle Side Harness C (SR-GM14H-HAR-C)8. Radio Replacement Interface (RP5-GM51)9. Steering Wheel Control Harness (GM5LIN-SW-HAR)10. Factory Rear Camera Adapter (CAM-GM51)11. IOB Display Harness (GM5CAM-DIS-HAR)12. Chime Module (CMX)13. Differential Video Adapter (RPA-VA1)Included Components14610852 1137912131. Does not retain the following factory features:2. Not compatible with vehicles equipped with Bose amplified audio system.3. Please make your vehicle settings selections before removing the factory radio for optimal installation time. Once the radiohas been removed, the vehicle settings which are normally selected through the factory radio can be accessed and changedby downloading and installing the PAC Vehicle Settings program from http://www.pac-audio.com/firmware4. The Voice button can be set to activate the factory OnStar function when pressed for longer than 1.5 seconds or giventhe ability to control the aftermarket radio. This option can be found in the PAC Vehicle Settings program mentioned above innote three. The default setting for this button is to control the factory OnStar. If this button is set to control the aftermarket radio,OnStar can still be accessed by using the mirror controls.● Factory satellite radio● Rear seat entertainment system (RSE)● Steering wheel control backlighting● Factory USB PortsPlastic Panel Tool7mm Socket10mm SocketPick ToolWire FeederRatchetTorx T15 ScrewdriverSmall Flat-blade ScrewdriverNOTE: Along with the SR-GM14H components,additional hardware and wire harnesses from theHEIGH10 (UN1810) kit will also be used in theinstallation.