PASCO AirLin k ® PS-32004 013-14636Cconnectors depending on whether they are digital oranalog.Use the PS-2158 PASPORT Analog Adapter to connect aScienceWorkshop analog sensor or sensor plug to theAirLink.Use the PS-2159 PASPORT Digital Adapter to connect aScienceWorkshop digital sensor to the AirLink.About the BatteryThe PASCO AirLink's battery is partially charged at thefactory. If the battery status LED blinks red, use the microUSB cable to connect the AirLink to a USB port or a USBcharger.Battery UsageBattery life is very important to making the sensor simpleand always ready to use, so all of the PASCO wirelessproducts are designed for long battery life. For example,the AirLink turns itself off after a few minutes of inactivity toconserve battery life..The battery life of the AirLink varies depending on thepower demand of the connected sensor and the samplingrate. The battery life between charges ranges between 11hours for high power sensors to more than 70 hours for lowpower sensors, with continuous sampling at a rate of onesample per second.In typical classroom/lab use, this would translate to a bat-tery life between charges ranging from one to four weeks ormore, because full-day continuous sampling at this sam-pling rate would be unusual. Even in the most extremecase with a high power sensor, AirLink would support of fullday of use before needing to recharge.Maximizing Battery LifeTwo factors that affect battery life are the storage tempera-ture and the number of charge cycles. Therefore, avoidstoring the AirLink in very cold or very hot environments.Because of the long battery usage time for the AirLink, thenumber of charge cycles is reduced, which lengthens bat-tery life.Troubleshooting the PASCO AirLink• If the PASCO AirLink loses Bluetooth connection andwill not reconnect, try cycling the ON button. Press andbriefly hold the button until the status LEDs blink insequence, and then release the button. Start theAirLink in the usual way.• If the AirLink stops communicating with the computersoftware or tablet application, try restarting thesoftware or application. If the problem remains, pressand hold the ON button for 10 seconds and thenrelease. Start the AirLink in the usual way.• Turn Bluetooth off and then turn it back on. Restart theAirLink.Technical SupportFor assistance with any PASCO product, contact PASCOat:The Reference Guide will be updated periodically. For thelatest revision of this Reference Guide, visit the PASCOWeb site atwww.pasco.com/manuals/Enter the product number, PS-3200, in the text window.Replacement PartsFor information about possible replacement parts, contactTechnical Support:USB Cable, Micro-to-USB AScienceWorkshopAnalog Sensor PlugScienceWorkshopDigital Sensor PlugScienceWorkshopAnalog SensorPS-2159 DigitalAdapterPS-2158 AnalogAdapterAddress: PASCO scientific10101 Foothills Blvd.Roseville, CA 95747-7100Phone: +1 916 462 8384 (worldwide)800-772-8700 (U.S.)Web: www.pasco.comEmail: support@pasco.com

PASCO AirLink PS-3200 Reference Manual