IMPORTANT SAFETY INSTRUCTIONSREAD AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS MACHINE!WARNING! To reduce the risk of fire, electric shock, or injury:1. You must be trained to operate this machine. This machine is to be operated for its intended use only.2. Do not operate this machine unless it is completely assembled.3. Always use a three-wire electrical system connected to the electrical ground. For maximum protection againstelectrical shock, use a circuit that is protected by a ground fault circuit interrupter. Consult your electricalcontractor.4. To prevent electrical shock: Always remove the electrical plug from the electrical outlet before performing anyrepairs, maintenance or cleanup and when leaving the machine unattended.5. To prevent electrical shock: Keep the machine surface dry; Do not subject to rain; Store the machine in a drybuilding area; Clean the machine with a dry cloth only.6. Machines can cause an explosion when near flammable materials and vapors. Do not use or store this machinewith or near fuels, grain dust, solvents, thinners, or other flammable materials. Do not use flammables to cleanthis machine.7. Maintenance and repairs must be done by a qualified or authorized person.8. If the machine is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,bring it to a service center.9. To avoid damage to the machine’s electrical cord, always lift the machine over the cord. Do not run the machineover the electircal cord.10. Make sure all labels, decals, warnings, cautions and instructions are fastened to the machine.This machine must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for electric current toreduce the risk of electric shock. This machine is equipped with a cord having an equipment-grounding conductor and grounding plug. Theplug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.WARNING - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electri-cian or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the machine.If it will not fit the outlet, have a proper outlet installed by a qualified electrician.This machine is for use on a nominal 120-volt circuit, and has a groundedplug that looks like the plug illustrated in figure A. A temporary adapterthat looks like the adapter illustrated in figures B and C may be used toconnect this plug to a 2-pole receptacle as shown in figure B if a properlygrounded outlet is not available. The temporary adapter should beused only until a properly grounded outlet (figure A) can be installedby a qualified electrician. The green colored rigid ear, lug, or the likeextending from the adapter must be connected to a permanent groundsuch as a properly grounded outlet box cover. Whenever the adapteris used, it must be held in place by a metal screw.NOTE: In Canada, the use of a temporary adapter is not permittedby the Canadian Electrical CodeEXTENSION CORDSUse only three-wire 16/3 or larger gauge approved extensioncords that have three-prong grounding type plugs and three-polereceptacles that accept the appliance’s plug. Replace or repair anydamaged cords or plugs.When servicing, refer to authorized person only. Use only identi-cal replacement parts.Grounding Instructions2NOTE: Do not use adapters shown in figures B & C in Canada