Packard Bell Stella Disassembly Manual

Contents

Packard Bell Stella Disassembly Manual Manual pdf 9 page image

8Fig. 9: Removing the floppy disk drive screws3. If required, remove the screws on the right side as well.4. Slide the floppy disk drive towards the front out of the bay.Removing the Hard Disk DriveTo remove the hard disk drive, first remove the rear bezel (see section Removing the RearBezel) and remove the left side cover (see section Removing the Left Side Cover), removethe front bezel (see section Removing the Front Bezel); then follow the steps below:1. Carefully disconnect the four-wire power cable and the flat data interface cablefrom the hard disk drive.Fig. 10: Disconnecting cables from the hard disk drive2. Remove the screws in the front of the chassis holding the hard disk drive bracket tothe chassis.Fig. 11: Removing the screws of the hard disk drive bracketPackard Bell Stella (iXtreme) Disassembly Manual