Palmako Ella Installation Manual

Also see for Ella: Installation manual Installation manual Installation manual Installation manual Installation manual

Installation manualHaving installed the roof boards, the roof felt and roofslats must be attached.The table of components shows whether the roofcover material and slats are included with thishouse option!First of all, screw the roof edge reinforcements and eaveedgings under the roof board ends. Then install the roofcover material.Installation of roof slats:Roof cover material (NB! Some house options do not include it in the kit!)Cut the roof felt in accordance with the roof length into suitable pieces and begin installing themparallel to the lower edge of the roof, moving toward the crest and placing the felt strips in the directionfrom the back wall to the front wall. The felt should extend from the edge by approximately 2-4 cm.Attach the roof felt to the roof boards with the supplied felt nails at intervals of about 15 cm. Make surethat the felt strips overlap by at least 10 cm.Having installed the roof cover material, attach thewind braces to the roof and the facia boards to therafters and upper wall logs.Installation of wind braces and facia boards:FloorOnly when the house is built completely you can install the floor boards, thus avoiding unnecessarysmudging on the floor.Place the floor boards on the base frame, tap them lightly against one another and then nail them withforce to the foundation joists. If necessary, cut the last floor board to the suitable width.The final operation is the fitting of the floor beadings to cover the spaces between the floor boards andwalls. If necessary, cut the floor beadings to the suitable length.ATTENTION: Depending on the climate at the house location, the floor boards can either swell ordiminish. If the floor boards are very dry while the climate is damp, they will easily absorb moisture. In