Palmako FR44-5341-2 Installation Manual

Also see for FR44-5341-2: Installation manual

Installation manual – EnglishApexIn most cases, the apex is supplied in one piece (attention: in some house options, the apex cancomprise several parts! In this case, these parts will have to be screwed together prior to otheractions). Having installed the last wall logs, place the apex on the front and back walls and attachthem with screws.The apexes have indents for the purlins. The purlins also have the corresponding indents, ensuringthat the roof is placed firmly and in the right place.Now place the purlins in thecorresponding indents in theapexes.Make sure that the upper wall log,apexes and purlins are level.Having fitted the purlins, screwthem onto the apex from above.Installation of purlins:ATTENTION: If the wall logs are not properly pressed on top of one another without gaps, the upperwall log may not be on the same level with the apexes. In this case you should tap the wall logsdownwards as necessary or plane the apex or sidewall log somewhat lower.RoofBefore installing the roof boards, make sure that the house is completely level. Use the water-level tocheck all walls.ATTENTION: When placing the roof, use a stable ladder. Do not step on the roof as the structure issuitable to sustain only an even load (snow, wind, etc.), and not a point load!Begin the installation of the roof boards from the front edge of the roof. Tap the boards lightly andattach them from above and below with nails to the purlins and upper wall log.ATTENTION: Do not press the roof boards together too densely and you will avoid moisture-causingbulging! Leave an interval of about 1 mm between the boards to allow for swelling.• During the whole process of installing the roof boards, make sure that their crest purlins coincideand the eave sides of the boards extend at a uniform distance. Verify this with a rope or the lateraleave lath that you may install for verification purposes.• The roof boards must be even with the purlin ends in front and behind. If necessary, saw both lastroof boards so narrow that they are even with the purlin ends.