Paloform caldera CIF-E-18 Installation Manual

Contents

Paloform caldera CIF-E-18 Installation Manual Manual pdf 7 page image

7CALDERA E CORTEN F IRE P IT | Owner and Installation ManualTO ASSEMBLE THE BURNER1. Connect the Burner Assembly to the gas/propane supplyusing the supplied flex connector and following theinstructions on page 8.2. Carefully leak test all connections following the procedureon page 8.3. Cover the burner pan evenly with burner media (lavapebbles OR glass) so that the burner ring is covered witha 1/2”-3/4” of media. Do not obstruct lighting port withburner media!4. Follow the Initial Lighting Instructions on page 10.Make sure that the flame carries to all parts of theburner. Turn OFF the appliance and let it cool beforeproceeding to the next step.5. Place decorative topping (if applicable), leaving the pilotcover exposed. Placement of toppings will affect theaesthetic character of the flame. Adjust positioningif necessary. Always completely extinguish burnerand pilot and wait for media to cool before makingadjustments.6. Do not cover pilot shield. Keep the lighting port openand free of media. Do not use any media not suppliedby the manufacturer!WARNING:Failure to position parts inaccordance with these diagramsand instructions and/or failure touse parts specifically approvedfor use with this appliance mayresult in property damage orpersonal injury.CAUTION:Do not remove the metal dataplates attached to the OutdoorFire Pit Burner. These platescontain important information.NOTICE:Installation and repair shouldbe done by a qualified serviceperson. The appliance shouldbe inspected before use and atleast once annually by a qualifiedservice person. More frequentcleaning may be required asnecessary. It is imperative thatcontrol compartment, burner andcirculating air passageways ofthe appliance be kept clean.BURNER ASSEMBLYLIGHTING PORTGLASS MEDIA (NG ONLY)LAVA MEDIA (LP & NG)“RIVER ROCK” TOPPING