Panasonic AG-AF100P Operating Instructions Manual

Also see for AVCCAM AG-AF100P: Operating instructions Operating instructions

Contents

Panasonic AG-AF100P Operating Instructions Manual Manual pdf 38 page image

38Removing SD Memory Card1 Lift the viewfinder up, and slide the card slotcover OPEN lever right to open.Ensure that the SD Memory Card access•lamp is not flashing orange before openingthe cover.2 Press the center of the SD Memory Card sothat it pops out slightly, and pull the cardstraight outwards.SD Memory Card access lampDo not remove the SD Memory Card or switch off•the power in the following circumstances. Doingso may damage your SD Memory Card.1) While the SD Memory Card access lamp is stillflashing orange after an SD Memory Card hasbeen inserted.2) While the SD Memory Card access lamp isflashing such as during recording or duringrecording finalization.Protecting SD Memory CardsMove the write-protect switch on the SD MemoryCard to the “LOCK” position to prevent recordedcontents being accidentally erased from the card.32LOCKWrite-protectswitchRepairing SD Memory CardsNever remove the SD Memory Card or disconnectthe battery or DC cord while the SD Memory Cardaccess lamp is flashing, as doing so may damagethe SD Memory Card. In the event that the SDMemory Card has been removed while the SDMemory Card access lamp was flashing, or thatthe battery or DC cord has been disconnectedduring recording or the recording finalizationprocess, a repair verification screen will bedisplayed the next time the power is switched on inorder to allow errors to be repaired.Select YES to begin repairing. When repairing iscomplete, “REPAIR FINISHED” will be displayed, andthe camera will switch to the recording paused screen.Select NO to switch directly to the recordingpaused screen without repairing.Memory cards cannot be repaired with the camera•if NO is selected, but can still be repaired by usingthe AVCCAM Restorer* contents repair software.An SD Memory Card on which an error occurred•can be repaired by using either the camerathat was used for the shooting, or the AVCCAMRestorer contents repair software.A repair confirmation message may be displayed•after inserting an SD Memory Card which has noerror, but repair will not be performed even whenYES or NO is selected.Repair may take up to 20 minutes or so depending•on the places where the errors occurred on the card.Use a battery with an adequate charge or the AC adaptor.•If the repair operation has failed, “SYSTEM•ERROR TURN POWER OFF” will be displayed.In this case, please use the AVCCAM Restorercontents repair software.Depending on the status of the data, it may not bepossible to restore all data completely. In this case,it will no longer be possible to play back the clipsthat were recorded before the power was turned off.Clips with a total recording time of less than 10•seconds may not be able to be repaired.Indexes attached during recording cannot be repaired.•* AVCCAM Restorer is included on the suppliedCD-ROM.For details on how to install it, refer to install.txt.For details on how to use it, read the operatinginstructions (PDF file).The AVCCAM Viewer can also be downloadedfrom the following website.http://pro-av.panasonic.net/Basic shooting operations (continued)